Forgot password

Electric bilge pump hose routing

  • June 01, 2013 9:01 PM
    Quote
    Message # 1307231
    Deleted user
    Hi All

    I needed to replace the 35 year old bilge hose (on my W32) that goes from the deep bilge to a port-side outlet right at the back near the rudder. I pulled out the old, broken 1 1/2" hose. Now I'm having great difficulty threading through the new 1 1/4" hose (to go w the new pump). Any one got any ideas about the best method/routing? There seems to be very little space......


    Thanks

    Chris
    TRILOGY -W32
  • June 01, 2013 9:03 PM
    Quote
    Reply # 1307238 on 1307231
    Deleted user
    PS - forgot a critical detail of the setup - this is a 1976 boat with the full engine room liner.


    Chris
    TRILOGY W32
  • June 13, 2013 8:37 PM
    Quote
    Reply # 1317892 on 1307231
    Deleted user
    Chris,

    Did you fix tis issue yet? I'm curious because I've got to do the same soon and wanted to know how you got it to fit. Good luck otherwise, wish I cold help. 
  • June 17, 2013 7:28 PM
    Quote
    Reply # 1320559 on 1307231
    Deleted user
    Turned out easy once I found out how... It goes down the port side just forward and to the side of the transverse piece of the engine room liner that the prop shaft goes through. My prop shaft goes through quite a large opening (I was able to replace the stern gland via it) and the bilge hose coming down needs to be shoved a little forward (and thus out of sight) between the end bit of the side of the liner and the hull. I have no pictures so I hope this is of some use.


    Chris

    Trilogy W32
Powered by Wild Apricot Membership Software